Error And Status Messages On The Screen - Sharp DX-C200 Quick Manual

Troubleshooting

Error and Status Messages on the Screen

"X" indicates the parts of the messages that appear differently depending on a spe-
cifi c situation, such as the paper sizes or types, tray names, or toner colors.
Message
(alphabetical order)
ADF Original
Misfeed
Open ADF Cover
and Remove paper.
Check Paper Size
Check Paper Type
Cover open
Dest. is not
Programmed
Failed to Access
File Press Clear key
Failed to Create File
Press Clear key
Causes
An original has been
jammed inside the
ADF.
The paper size set for
the document differs
from the size of the
paper in the tray.
The paper type set for
the document differs
from the type of the
paper in the tray.
A cover is open.
No Quick Dial entry
is associated with the
One Touch button you
pressed.
The Scan to USB
function failed
because the machine
could not access
the USB fl ash disk
properly.
The Scan to USB
function failed
because there was
not enough memory
on the USB fl ash disk.
Solutions
• Remove jammed originals,
and then place them again.
See "Removing from the ADF"
on page 34.
• Check the originals are suit-
able for scanning. See "Plac-
ing Originals", User Guide.
Press [FormFeed] to begin
printing, or press [JobReset] to
cancel the job.
Press [FormFeed] to begin
printing, or press [JobReset] to
cancel the job.
Close the cover completely.
• Press a different One Touch
button.
• Assign a registered destination
to the One Touch button. See
"Registering Scan Destina-
tions", User Guide.
Use a USB fl ash disk that is not
password- or write-protected.
Use a USB fl ash disk with
enough memory.
23