Creating A Synthesizer Part By Using Arpeggio - Yamaha MOX6 Owner's Manual

6
Press the [REC] button to return to the Song
Record display.
7
Press the [P] (Top) button to return to the top of
the Song, then press the [F] (Play) button to start
recording.
As soon as the lead-in count (1-measure) is finished, play
the following notation.
8
After playing the above notation, press the [J]
(Stop) button to stop recording.
If you play any wrong notes, press the [J] (Stop) button,
then try recording again. Repeat as often as necessary until
you get it right.
9
Press the [P] (Top) button followed by the [F]
(Play) button to hear the recorded data.
The recorded data of the Tracks 1 and 2 will be played back.
To stop playback, press the [J] (Stop) button. If you are not
satisfied with the recorded data, try this operation again.
HINT
Re-recording a specific part of a Song
(Punch In/Out)
Use the Punch In/Out recording method to record over only a
specific portion of the Track. If you set the start point (Punch In)
and end point (Punch Out), and then start recording from the
top of the Song, the actual recording will be done only between
the Punch In and Punch Out points. In the eight-measure
example below, only the third through the fifth measures are re-
recorded.
Before re-recording
Recording start
Punch In point
1 2 3 4
After re-recording
1 2 3 4
Newly recorded data
NOTE
Punch In/Out Recording can only be used with Realtime
recording.
NOTE
Note that the Punch In/Out method always replaces
(destroys) the original data over the specified area.
To execute Punch In/Punch Out recording in the above condition,
set the following parameters beforehand on the [F1] SETUP
display in the Song Record mode.
• "Type" = "punch"
• Punch In = 003:01
• Punch Out = 006:01
Recording stop
Punch Out point
5 6 7 8
5 6 7 8
Punch In point
Playback of the recording Track is turned off from this point,
and your keyboard performance will be recorded to the Track.
Punch Out point
Recording ends at this point and normal
playback of the recording Track starts.
[SF1] COPYLOC button
Press the [SF1] COPY LOC to assign the measure numbers
registered to the Locations (Loc1 and Loc2) to the Punch
In and Punch Out points.
NOTE
For instructions on using the Location settings, see the
"Reference Manual" PDF document.
Creating a synthesizer part by
using Arpeggio
Next, record Arpeggio playback via Realtime Recording to
Track 3.
1
In the Song Play mode, select the same Song to
which the Drum and Bass parts have already been
recorded.
2
Press the ARP [ON/OFF] button so that its lamp
lights.
3
Press the [REC] button, followed by the [F1]
SETUP button, then set the parameters as below.
• "Type" = "replace"
• "Quantize" = "off"
• "Rec Track" = "3"
4
Press the [F2] VOICE button, followed by the
[CATEGORY SEARCH] button then select the
Synthesizer Voice.
Set the Main Category to "Synth Pad" then set the Sub
Category to "Analog." Move the Cursor [>] button to call up
the Voice List. From this list, select "PRE5 H04 Saw Pad"
then press the [ENTER] button.
Quick Guide
MOX6/MOX8 Owner's Manual
41