Brother PT 2300 - P-Touch 2300 Thermal Transfer Printer User Manual page 72

Error Message
NO
TAPE!
REPLACE
BATTERIES!
ROM
PROBLEM!
SOLDER X
TAB
LIMIT!
TEXT
TOO HIGH!
TEXT
TOO LONG!
68
Cause
This message appears if you try to print
a label or feed the tape when no tape
cassette is installed.
This message appears if the installed
alkaline batteries are about to run
out.
This message appears if there is a
problem with the machine's read
only memory.
This message appears if there is a
problem with the machine's software.
This message appears if the maximum
number of tabs has already been added
to the text when you hold down c
and press Q.
This message appears if the size of
the text is larger than the width of the
installed tape.
This message appears if the length of
the text is longer than the label length
that has been set using the Length
function.
Remedy
Install a tape cassette and try
again.
Replace the batteries or use the
AC adaptor.
Contact your service representa-
tive.
Turn off the machine, and then
while holding down c and
R, turn the machine back on.
Contact your service representa-
tive.
Limit the number of tabs in the
text to 50.
Reduce the size of the characters
or install a wider tape.
Delete some of the text, reduce
the character width or increase
the set label length.