Brother PT 2300 - P-Touch 2300 Thermal Transfer Printer User Manual page 71

Error Message
CUTTER This message appears if the tape cut-
ERROR! ter is closed when you try to print or
feed the tape.
EEPROM This message appears if a checksum
ERROR! error occurred when the P-touch was
turned on or if the keyword was dam-
aged and it failed to initialize.
INTERFACE This message appears if an error
ERROR! occurs while data is being sent from
the computer to the P-touch.
INVAL. This message appears if the cursor is
CHRS! not below a number when you hold
down c and press O.
LENGTH • This message appears if the text is
LIMIT!
• This message appears if the Length
• This message appears if the Tab
LINE This message appears if the number
LIMIT! of lines in the text is greater than the
maximum number of lines possible
for the installed tape.
MEMORY This message appears if you try to
FULL! store a text file after the maximum
number of characters has already
been stored in the memory.
NO This message appears if you try to
FILES! recall or delete a text file from the
memory when none are stored.
Cause
longer than 3' 3 1/3" (1 meter) when
you try to print.
function is used to set a label
length that is less than 1.6" (4.0
cm) or more than 11.8" (30.0 cm).
Length function is used to set a tab
length that is more than 11.8"
(30.0 cm).
Remedy
Turn the P-touch off, then on
again.
Contact your service representa-
tive.
Cancel the print job, and then
try printing again.
Move the cursor below a
number before holding down
c and pressing O.
• Shorten the text to less than 3'
3 1/3" (1 meter) before trying
to print.
• Set the label length between
1.6" (4.0 cm) and 11.8" (30.0
cm).
• Set the tab length so that it is
less than 11.8" (30.0 cm).
Reduce the number of lines or
install a tape of greater width.
Delete an unwanted file to make
room for the new one.
Store a text file first.
67