Setting The Passcode To Prevent Unauthorized Access - Yamaha disklavier DKC-850 Function Manual

3
Press [+/YES] and [–/NO] to change the brightness.
=Display=
*Brightness=80%
*Dim light=OFF
The following brightness settings are available: 40%, 60%, 80%,
100%.
4
To set the time for the display to dim, press [
the cursor to the dim light parameter, then press [+/YES]
and [–/NO].
The following time settings are available: OFF, 1min, 2min, 3min,
5min, 10min, 15min, 30min, 45min, 60min.
If there is no operation for the time set above, the display dims to
half the brightness of its original setting.
5
Press [ENTER] to complete the operation.

Setting the Passcode to Prevent Unauthorized Access

[SETUP] "Passcode"
You can enter the 4-digit passcode to prevent unauthorized access from
the commercially available external remote controller, or you can also set
the MAC address of the external remote controller to allow it to access your
Disklavier without entering the passcode.
English
?=-+ENT
] to move
?=-+ENT
=Display=
*Brightness=100%
*Dim light=1min.
Other Settings
Note:
The brightness of the display will
return to its original setting when you
press any buttons, insert media, or
eject media.
Note:
These settings are not required for
the use of the remote control of this
unit. In case of using an external
remote controller, refer to the user's
guide for that remote controller.
Note:
If changes are inappropriately made
for these settings, the external remote
controller may not function properly.
In such cases, enter "####" to reset
the passcode setting.
Continued on next page
11