Parameters From The Modulation Effect Block - Yamaha CP1 Owner's Manual

Parameters from the Modulation Effect Block

Editing Sequence: Press and hold the [MODULATION EFFECT 1] or [MODULATION EFFECT 2] button (for at least one second)
 Turn Knobs 2 to 6
Each type of modulation effect is configured using a different set of parameters, which adjust the sound of the effect in
various ways. In the following table, you will find a description of all such parameters in alphabetic order.
NOTE For more details on the specific parameters associated with each different type of modulation effect, see the Modulation Effect block's parameter
list in the Data List booklet.
On-screen name
(and full name)
B Bottom
C Color
D Delay
Depth
Drive
F Feedback
M Manual
Mix
Mode
P Pedal Control
Phase
R Rate
Reso
(Resonance Offset)
S Sens.
(Sensitivity)
Speed
T Top
Type
Associated effect types
Touch Wah and Pedal Wah
SmallPha
Symphonic
Flanger, Chorus, 816chorus,
and Symphonic
SmallPha and Max90
Touch Wah and Pedal Wah
Flanger and 816Chorus
Flanger
Flanger, Chorus, 816Chorus
and Symphonic
Max100
Pedal Wah
816Chorus
SmallPha
Touch Wah and Pedal Wah
Touch Wah
Max90, Max100, Flanger,
Chorus, 816Chorus, and
Symphonic
Touch Wah and Pedal Wah
Max90
D Chorus
Description
This parameter is used to set the lowest point in the filter's sweep range.
This parameter is used to adjust the way in which the phaser sweeps.
This parameter is used to set the delay-time offset for modulation.
This parameter is used to set the degree to which modulation is applied.
This parameter is used to set the phaser's input level.
This parameter is used to adjust the way in which the sound distorts.
This parameter is used adjust the degree to which output from the effect
is fed back into its input.
This parameter is used to set the offset value for delay modulation.
This parameter is used to adjust the volume of the effect sound.
This parameter is used to select the phaser mode.
This parameter is used to set the cutoff frequency for the wah filter.
This parameter is used to set the phase offset for the chorus effect.
This parameter is used to adjust the phaser speed.
This parameter is used to set the resonance offset value.
This parameter is used to adjust how sensitive the filter-sweep effect is to
key velocity.
This parameter is used to adjust the modulation speed.
This parameter is used to set the highest point in the filter's sweep range.
This parameter is used to select the phaser type.
This parameter is used to select the chorus type.
Modulation Effect
47
CP1 Owner's Manual