Reverb - Yamaha CP1 Owner's Manual

Reverb

Reverb
The Reverb block can be used to apply a reverberation type effect to both Part 1 and Part 2.
Editing Sequence:
RevType
(Reverb Type)
RevTime
(Reverb Time)
1RevSend
(Reverb Send 1)
2RevSend
(Reverb Send 2)
FBHiDamp
(Feedback High Damping)
HPF
(High-pass Filter Cutoff)
50
CP1 Owner's Manual
Press and hold the [REVERB] button (for at least one second)  Turn Knobs 1 to 5
This parameter is used to select the type of reverb to be applied.
Setting values: RichHall, RichPlt, RichRoom, WoodRoom, Room1, Room2, Stage1, or Stage2
RichHall (Rich Hall)
RichPlt (Rich Plate)
RichRoom (Rich Room)
WoodRoom (Woody Room)
Room1
Room2
Stage1
Stage2
This parameter is used to set how long it takes for the reverb sound to fade to silence.
Setting values: WoodRoom: 0.3 to 10.0 (seconds), Other reverb types: 0.3 to 30.0 (seconds)
These parameters are used to set how much of the output signal from Part 1 and Part 2, respectively, is sent
to the reverb effect. Higher values produce a more pronounced reverb sound.
Setting values: 0 to 127
This parameter is used to adjust the brightness of the reverb sound. At higher settings, it takes longer for the
high-frequency component to decay, producing a brighter overall reverb sound. This parameter is not
displayed on-screen when RevType has been set to "WoodRoom".
Setting values: 0.1 to 1.0
This parameter is used to set the cutoff frequency for the Reverb block's high-pass filter.
Setting values: 20Hz to 8.0kHz
Emulation of hall acoustics with a rich, deep reverb sound.
Emulation of a rich, sustained plate sound.
Emulation of room acoustics with a gentle reverb sound.
Emulation of room acoustics with a warm reverb sound.
Emulation of room acoustics with a crisp reverb sound.
Emulation of room acoustics with a deeper reverb sound.
Emulation of stage acoustics with wide, sustained reverb sound.
Emulation of the reverb typical of a smaller stage.