Parameters From The Power-Amplifier / Compressor Block - Yamaha CP1 Owner's Manual

Parameters from the Power-Amplifier / Compressor Block

Editing Sequence: Press and hold the [POWER AMPLIFIER/COMPRESSOR 1] or [POWER AMPLIFIER/COMPRESSOR 2] button
(for at least one second)  Turn Knobs 2 to 6
Each power-amplifier / compressor type is configured using a different set of parameters, which adjust the sound
produced by the block in various ways. In the following table, you will find a description of all such parameters in
alphabetic order.
NOTE For more details on the specific parameters associated with each different power amplifier / compressor type, see the Power-Amplifier /
Compressor block's parameter list in the Data List booklet.
On-screen name
(and full name)
A Attack
D Drive
L LineBal
(Line Balance)
O Output
R Ratio
Release
S SpType
(Speaker Type)
Associated power amplifier /
compressor types
Compressor 376
PowerAmp 71Rd I, PowerAmp 73Rd I,
PowerAmp 75Rd I, PowerAmp 78Rd II,
PowerAmp 69Wr, and PowerAmp 77Wr
Compressor 376
PowerAmp 71Rd I, PowerAmp 73Rd I,
PowerAmp 75Rd I, PowerAmp 78Rd II,
PowerAmp 69Wr, and PowerAmp 77Wr
PowerAmp 71Rd I, PowerAmp 73Rd I,
PowerAmp 75Rd I, PowerAmp 78Rd II,
PowerAmp 69Wr, PowerAmp 77Wr,
Compressor 376, and Clean Amp
Compressor 376
Compressor 376
PowerAmp 71Rd I, PowerAmp 73Rd I,
PowerAmp 75Rd I, PowerAmp 78Rd II,
PowerAmp 69Wr, and PowerAmp 77Wr
Power-Amplifier / Compressor
Description
This parameter is used to set the amount of time that elapses
between playing a note and activation of the compressor.
This parameter is used to adjust the way in which the sound
distorts. In order to produce an effect, the LineBal parameter's
speaker output (S) must be raised by a certain amount. If the line
output (L) is maximized, Drive will have no effect.
This parameter is used to adjust the degree to which
compression is applied.
This parameter is used to adjust the balance between the
speaker output (S) and line output (L).
This parameter is used to set the output level.
NOTE The Output parameter's setting value is retained when the
power-amplifier / compressor type is changed. When a new
Performance is selected, however, the value from the
corresponding Performance data will be set.
This parameter is used to set the compression ratio.
This parameter is used to set the amount of time over which the
compressor stops compressing the sound.
This parameter is used to select different speaker types.
49
CP1 Owner's Manual