Table of Contents
Advertisement
CPU Q-Fan Function [Enabled]
Enables or disables the CPU Q-Fan control feature. Configuration options: [Disabled]
[Enabled]
The following item appears only when you set CPU Q-Fan Function to [Enabled].
CPU Fan Speed Low Limit [200 RPM]
Allows you to manually set a lower limit for the CPU fan speed. If the CPU fan speed is below
the specified limit, the system sends out warning beeps. Configuration options: [500 RPM]
[400 RPM] [300 RPM] [200 RPM] [100 RPM] [Ignored]
CPU Q-Fan Mode [Standard]
This item appears only when you enable the CPU Q-Fan Function feature and allows you to
set the appropriate performance level of the CPU fan.
[Standard]
[Silent]
[Turbo]
[Manual]
2.5.6
EuP Ready [Disabled]
[Disabled]
[Enabled]
2.6
Boot menu
The Boot menu items allow you to change the system boot options. Select an item then
press <Enter> to display the sub-menu.
Main
Advanced
Boot Settings
Boot Device Priority
Boot Settings Configuration
Security
2-18
Sets to [Standard] to make the CPU fan automatically adjust depending on
the CPU temperature.
Sets to [Silent] to minimize the fan speed for quiet CPU fan operation.
Set to [Turbo] to achieve maximum CPU fan speed.
Allows you to individually set the CPU fan parameters.
Disables the Energy Using Products (EuP) Ready function.
Allows BIOS to switch off some power at S5 state to get system ready for
the EuP requirement. When set to [Enabled], power for WOL, WO_USB,
audio and onboard LEDs will be switched off at S5 state.
M4A78LT PLUS BIOS Setup
Power
v02.61 (C)Copyright 1985-2011, American Megatrends, Inc.
Boot
Tools
Exit
Version 0202
Specifies the Boot
Device Priority
sequence.
A virtual floppy disk
drive (Floppy Drive B:)
may appear when you set
the CD-ROM drive as the
first boot device.
Select Screen
Select Item
Enter Go to Sub Screen
F1
General Help
F10
Save and Exit
ESC
Exit
Chapter 2: BIOS information
Advertisement
Table of Contents
