Table of Contents
Advertisement
The following items only appear when a USB storage device is plugged in.
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay [20 Sec]
Sets the maximum time that the BIOS waits for the USB storage device to initialize.
Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to set the emulation type. Configuration options: [Auto] [Floppy]
[Forced FDD] [Hard Disk] [CDROM]
2.5
Power menu
The Power menu items allow you to change the settings for the Advanced Configuration and
Power Interface (ACPI) and the Advanced Power Management (APM). Select an item then
press <Enter> to display the configuration options.
Main
Advanced
Power Settings
Suspend Mode
ACPI 2.0 Support
ACPI APIC support
APM Configuration
HW Monitor Configuration
EuP Ready
2.5.1
Suspend Mode [Auto]
Selecta the Advanced Configuration and Power Interface (ACPI) state to be used for system
suspend. Configuration options: [S1 (POS) Only] [S3 Only] [Auto]
2.5.2
ACPI 2.0 Support [Enabled]
Enables or disables the Advanced Configuration and Power Interface (ACPI) 2.0 support.
Configuration options: [Disabled] [Enabled]
2-16
M4A78LT PLUS BIOS Setup
Power
[Auto]
[Enabled]
[Enabled]
[Disabled]
v02.61 (C)Copyright 1985-2011, American Megatrends, Inc.
Boot
Tools
Exit
Version 0202
Select the ACPI state
used for System
Suspend.
Select Screen
Select Item
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
Chapter 2: BIOS information
Advertisement
Table of Contents
