Indicators And Projector Condition - Eiki XGA "Diamond" Series LC-XD25 Owner's Manual

Indicators and Projector Condition

Check the indicators for projector condition.
Indicators
POWER
WARNING
red
red/green
• • • green
• • • blinks green
✽ When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow.
When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp
replacement counter after replacing the lamp. See pages 60-62.
LAMP
REPLACE
yellow
The projector is off. (The AC power cord is unplugged.)
The projector is preparing for stand-by or the projection lamp is
being cooled down. The projector cannot be turned on until cooling
✽
is completed.
The projector is ready to be turned on with the POWER ON/STAND-
✽
BY button.
The projector is operating normally.
✽
The projector is in the Power management mode.
✽
The temperature inside the projector is abnormally high. The
projector cannot be turned on. When the projector is cooled
down enough and the temperature returns to normal, the POWER
✽
indicator lights red and the projector can be turned on. (The
WARNING indicator keeps blinking.)
The projector has been cooled down enough and the temperature
returns to normal. When turning on the projector, the WARNING
✽
indicator stops blinking. Check and clean the air filter.
The projector detects an abnormal condition and cannot be turned
on. Unplug the AC power cord and plug it again to turn on the
projector. If the projector is turned off again, disconnect the AC
✽
power cord and contact the dealer or the service center for service
and checkup. Do not leave the projector on. It may cause an electric
shock or a fire hazard.
• • • red
• • • blinks red
Projector Condition
• • • off
Appendix
6