Maintenance And Cleaning; Warning Indicator - Eiki XGA "Diamond" Series LC-XD25 Owner's Manual

Eiki international multimedia projector owner's manual
Hide thumbs Also See for XGA "Diamond" Series LC-XD25:
Table of Contents

Advertisement

Maintenance and Cleaning

Warning indicator

The WARNING indicator shows the state of the function which protects the projector. Check the state of the
WARNING indicator and the POWER indicator to take proper maintenance.
T he project o r i s sh ut dow n a n d the WA R N I N G
indicator is blinking red .
When the temperature inside the projector reaches a
certain level, the projector is automatically shut down to
protect the inside of the projector. The POWER indicator
is blinking while the projector is being cooled down. When
the projector has cooled down sufficiently (to its normal
operating temperature), it can be turned on again by
pressing the POWER ON/STAND-BY button.
Note:
After the temperature inside the projector returns
to normal, the WARNING indicator still continues
to blink. When the projector is turned on again, the
WARNING indicator stops blinking.
Then check the matters below:
– Did you provide appropriate space for the projector to
be ventilated? Check the installing condition to see if
ventilation slots are not blocked.
– Is the projector not installed near the ventilation duct of
air-conditioning equipment which may be hot? Install
the projector away from the ventilation duct of air-
conditioning equipment.
– Is the air filter clean? Clean the air filter periodically.
(p.58)
T he project o r i s sh ut dow n a n d the WA R N I N G
indicator emits a red light .
When the projector detects an abnormal condition, it is
automatically shut down to protect the inside and the
WARNING indicator becomes red. In this case, disconnect
the AC power cord and reconnect it, and then turn the
projector on once again for check. If the projector cannot
be turned on and the WARNING indicator emits a red light,
disconnect the AC power cord and contact the service
station for check and repair.
CAUTION
DO NOT LEAVE THE PROJECTOR WITH THE
AC POWER CORD CONNECTED UNDER THE
ABNORMAL CONDITION. IT MAY RESULT IN
FIRE OR ELECTRIC SHOCK.
Top Control
Top Control
WARNING
blinking red
WARNING
lights red
57

Advertisement

Table of Contents
loading

Table of Contents

Save PDF