Sharp PG-LW3000 Operation Manual page 24

Equipment
Camera/Video game
Monitor
Amplifier
Note
• You can also use the MONITOR OUT terminal as the COMPUTER/COMPONENT 2 terminal. To use
this terminal as an output terminal, set "COMPUTER2 Select" to "Monitor Output" before connecting
the external equipment. (See page 52.)
• When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm
stereo audio cable.
• You can select AUDIO 1 or AUDIO 2 in the INPUT list. (See page 30.)
• RGB signals and Component signals can be output to the monitor.
This projector is able to process the following signals when connected to HDMI
equipment:
• Video signal: For details, see "Digital Support" in the list of "Compatibility Chart" on page 67.
• Audio signal: Linear PCM audio
• Sampling frequency: 48kHz/44.1kHz/32kHz
22
Terminal on
connected equipment
Cables for a camera or a video game/3 RCA to
mini D-sub 15 pin cable (commercially available)
Component
video
output
terminal
Cables for a camera or a video game
Video
output
terminal
RGB RGB cable (supplied or commercially
input available)
terminal
ø3.5 mm stereo or mono audio cable
ø3.5 mm
(commercially available or available
audio input
as Sharp service part QCNWGA038WJPZ)
terminal
ø3.5 mm stereo minijack to RCA audio cable
RCA audio
(commercially available)
input
terminal
Cable
RCA adaptor plug
(commercially available)
Terminal on the
projector
COMPUTER/
COMPONENT 1, 2
VIDEO
MONITOR OUT
AUDIO OUT