Xerox DocuPrint 155 Troubleshooting Manual page 30

Clearing paper misfeeds and jams
5-4
Clean the feed belt only to correct misfeeds, not as routine
maintenance. Because the belt is rubber, frequent cleaning dries
it out and makes it fail prematurely.
1. Clear any misfeeds that have occurred, but do not latch the
paper feeder assembly. If necessary, unlatch it by pressing
down on the bright green lever on the right side of the paper
tray.
2. Lightly moisten a lint-free towel with film remover and
thoroughly wipe the outside surface of the feed belt in the
same direction as the ribs on the belt. (Wiping from side to
side might pull the belt off its track.) Allow a few seconds for
the film remover to evaporate.
CAUTION
Troubleshooting Guide