Setting Up The System - Raytheon RayChart 620 Operation Manual

Chapter 6: Customizing the RayChart 620
5. Use the up and down trackpad controls to move the selection bar
6. Press ENTER to accept the new setting, or CLEAR to cancel the
7. Once you have reset all the required values, press CLEAR.
You can return all the settings to their original factory settings, if
required, by performing a master reset, as described in Chapter 8.

Setting Up the System

The SYSTEM option from the Set Up menu allows you to set up your
system preferences.
The following table lists the System parameters or menus and their
options, shows the factory default setting, and provides a space for you
to make a note of your new default setting. Each parameter or menu is
described in the following subsections.
For parameters, a window appears listing the settings available,
with the current setting highlighted. For parameters that have a
numeric value, a single value (or OFF) is displayed, that can be
adjusted.
up and down the list, or to increase or decrease the value. To
change a value quickly you can press and hold the trackpad.
change. The options window is cleared from the menu.
If you were in a sub-menu, the previous menu is displayed and you
can continue changing parameter settings.
If you were in one of the set up menus, you are returned to the
default display.
D3836-1
59