Chapter 7: Installation
If your Raytheon equipment is going to be connected to other
equipment using a cable not supplied by Raytheon, a suppression
ferrite MUST always be fitted to the cable close to the Raytheon unit.
7.4 Mounting the RayChart
The RayChart can be mounted using the trunnion (yoke) bracket
already fitted, or panel mounted using the supplied mounting kit.
Trunnion Mounting
To mount the RayChart using the trunnion bracket:
1. Loosen the trunnion knobs on each side of the RayChart, and
2. Mark the locations of the trunnion screw holes on the mounting
3. Use the screws supplied to fix the trunnion at the marked locations.
4. Fit the RayChart to the trunnion, adjust the display angle and tighten
Panel Mounting
To mount the RayChart on a tabletop or console (as shown in the
illustration on the following page):
1. Select a clear location at least 350mm (13¾ in) by 250mm (9¾ in).
2. Unpack the panel-mounting kit.
3. Using the supplied template, trace out the appropriate screw hole
4. Drill a 12.7mm (½ in) pilot hole in each opposing corner of the
5. Using a suitable saw, cut along the outside edge of the cut-out line.
6. Remove the trunnion (yoke) knobs and bracket from the RayChart.
7. Drill four 5mm (
8. Complete the installation of the power data cabling, GPS input, and
remove the trunnion from the unit.
surface.
the knobs.
Caution: Make sure there are no hidden electrical wires or other
items behind the desired location before proceeding. Check that
you have free access for mounting and cabling.
locations for panel mounting, and the display unit opening.
cut-out area.
Make sure that the unit fits in the cut-out area.
1
/
in) holes in the marked locations.
5
any other accessory cables to the console (see Section 7.5).
83