Editing The Waypoint Details; Clearing Or Changing A Go To - Raytheon RayChart 620 Operation Manual

22
3. Press the EDIT soft key, that is displayed for 7 seconds, if you wish

Editing the Waypoint Details

You can change the new waypoint's name, symbol and position.
To edit the waypoint details:
1. Press the EDIT soft key that is displayed for 7 seconds after you
2. Use the left or right sides of the trackpad to move the cursor to the
3. Use the top or bottom of the trackpad to increase or decrease the
4. Repeat steps 2 and 3 until the required information is displayed.
5. Press ENTER to save the details.

Clearing or Changing a GO TO

If you are already tracking to a waypoint when you request a GO TO,
the RayChart displays the following message:
The waypoint is shown as a circle with a dot in the center, and is
connected to the vessel's starting position with a dashed line. The
waypoint is given a default name of the format xxx WPT, where xxx
is the next available waypoint number.
to change any of the waypoint information for the new waypoint:
request the GO TO. A window such as the following is displayed:
number, letter or symbol you wish to change. You can hold the
trackpad down to move quickly.
number, or change the letter or symbol.
D3825-1
D3824-1
RayChart 620