Installing The Stand - ViewSonic CDE6501LED User Manual

Getting Started

Installing the stand

If the stand is provided, please read these instructions thoroughly before
attempting this installation.
You must install your Display into the stand in order for it to stand upright on a
cabinet or other flat surface. If you intend to mount your Display on a wall or other
vertical surface, you must remove the stand column.
Cautions:
• Make sure that you handle your Display very carefully when attempting assembly or
removal of the stand. If you are not sure of your ability to do this, or of your ability
to use the tools necessary to complete this job, refer to a professional installer or
service personnel. The manufacturer is not responsible for any damages or injuries
that occur due to mishandling or improper assembly.
• When using a table or bench as an aid to assembly, make sure that you put down
a soft cushion or covering to prevent accidental scratching or damage to your
Display's finish.
• The speaker is not intended to support the weight of your Display. Do not move or
handle your Display by the speaker. This can cause damage to your Display that is
not covered by the manufacturer's warranty.
• Before attempting assembly or removal of the stand, unplug the AC power cord.
Locating grooves
Locators
Stand
3. Put the stand column close to the back of the Display, align the locating grooves on
the stand column with the Locators on the Display, and align the screw holes on
the stand column with the holes on the Display, then secure the stand column to
the Display with four provided screws.
4. Align the screw holes on the stand column with the holes in the stand, then secure
the stand to the Stand column with five provided screws.
After stand installation, if you find the stand is not stable horizontally,please
do the following:
Place the Display face-down on a cushioned surface, loosen the four screws securing
the set to its stand column (note that only loosen a little, not detach the screws),then
tilt the column toward lower position, then tighten these screws again.
Note: 1. The appearance of this product in these illustrations may differ from your
actual product,and is for comparative purposes only.
2. We may change the design and specifications without notice.
(Continued)
To install the stand:
1. Remove the stand from the box and place
Secure with
four screws
Stand Column
2. Lay your Display flat (screen down) on
Secure with
five screws
2
it on a table or bench.
You must pay attention to the direction
of the stand. The wide portion of the
stand should go towards the front of the
Display.
the edge of a table or bench. Make sure
that you put down a soft cushion or cloth
so that yourDisplay is not scratched.