Connecting The Ac Power Cord - Eiki LC-SD15 Owner's Manual

Installation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-120 V or 200-240
V AC and it automatically selects a correct input voltage. It is
designed to work with the single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service station. Connect the projector
with all peripheral equipment before turning on the projector. (See
pages 15 and 16 for connection.)
CAUTION
For safety, unplug the AC power cord when the projector is not
in use. When the projector is connected to an outlet with the
AC power cord, it is in stand-by mode and consumes a little
electric power.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and a proper AC power cord must be
used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side
14
For the U.S.A. and Canada
Ground
To power cord
connector on your
projector.
Connect the AC power cord (supplied) to the
projector.
The AC outlet must be near this equipment and
must be easily accessible.
AC outlet side
For Continental Europe
To the AC outlet.
(120 V AC)
To the AC outlet.
(200 - 240 V AC)