Cautions - Insignia NS-59P680A12 User Manual

Cautions

Damage requiring service
Unplug this TV from the power outlet and refer
servicing to qualified service personnel under the
following conditions:
• When the power supply cord or plug is damaged
or frayed.
• If liquid has been spilled or objects have fallen
into your TV.
• If your TV has been exposed to rain or water.
• If your TV does not operate normally by following
the operating instructions. Adjust only those
controls that are covered by the operating
instructions because incorrect adjustment of
other controls may result in damage and will
often require extensive work by a qualified
technician to restore your TV to its normal
operation.
• If your TV has been dropped or damaged in any
way.
• When your TV exhibits a distinct change in
performance.
Outdoor antenna grounding
If an outside antenna or cable system is connected
to your TV, make sure that the antenna or cable
system is grounded to provide some protection
against voltage surges and built-up static charges.
Article 810 of the National Electrical Code,
ANSI/NFPA No. 70, provides information with
respect to correct grounding of the mast and
supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding
conductors, location of the antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode.
7
1 Antenna lead-in wire
2
Grounding clamp
3 Antenna discharge unit
4
Grounding conductors
5
Ground clamps
6 Power service grounding electrode system
7 Electric service equipment
Note to CATV system installer
Condensation
Mobile telephone warning
End of life directives
Non-active pixels
1
2
3
4
Altitude
5
6
Heat on the top of the plasma TV
www.insigniaproducts.com
Article 820 of the National Electrical Code,
ANSI/NFPA No. 40 provides guidance for correct
grounding. Specifically, it states that the cable
ground must be connected to the grounding
system of the building as close to the point of cable
entry as practical.
Moisture will form on the TV if the TV is brought
from cool surroundings into a warm room or if the
temperature of the room rises suddenly. When this
happens, the TV's performance may be impaired. To
prevent this, let the TV stand in its new
surroundings for about an hour before switching it
on, or make sure that the room temperature rises
gradually.
Condensation may also form during the summer if
the TV is exposed to the breeze from an air
conditioner. In such cases, change the location of
the TV.
To avoid interference with your TV picture and
sound, operating problems, or even damage, keep
your cordless and cellular telephones away from
the TV.
Your TV contains tin-lead solder and a fluorescent
lamp containing a small amount of mercury.
Disposal of these materials may be regulated for
environmental reasons. Your TV also contains
material that can be recycled and reused. For
disposal or recycling information, contact your local
authorities.
The plasma display panel contains almost 3 million
thin film transistors, which provide exceptionally
sharp video quality. Occasionally, a few non-active
pixels may appear on the screen as a fixed blue,
green, or red point. These non-active pixels do not
adversely affect the performance of your TV, and
are not considered defects.
The plasma display panel can only operate normally
at heights under 6,500 feet.
The top side of the product may be hot after long
periods of use as heat dissipates from the panel
through the vent hole in the upper part of the
product. This is normal and does not indicate any
defect or operation failure of the product. However,
children should be prevented from touching the
upper part of the product.
3