Operating The Tape Playback Functions - Canon 9540A003 - Optura 400 Camcorder Instruction Manual

Operating the Tape Playback Functions

When you play back a tape on your camcorder, you can send recorded video and
sound to your contact. You can also control the playback functions from the DVM
panel while monitoring the picture in the [Conversation] window.
You cannot send video or sound recorded in extended recording modes
( SP/ LP). If you play back a tape recorded in extended recording
modes, the picture in the [Conversation] window may be distorted.
If your contact fast forwards, rewinds or stops the tape during playback,
Windows Messenger will continue to show the last picture. If the tape is
played back again, the playback picture appears.
Depending on the camcorder, Windows Messenger may produce noises
such as buzzing sound when you pause playback or use the playback
control lever. This is not a malfunction.
Camcorder without NETWORK mode: If you operate the tape using the
camcorder buttons or the wireless controller, the display on the DVM panel
may not reflect the actual operation for a short time.
1
Set the camcorder to NETWORK mode.
(Camcorder without NETWORK mode: Set the camcorder to
PLAY (VCR) mode.)
2
To operate your camcorder:
Click the [MY CAMERA] tab followed by the
(Camcorder without NETWORK mode: Click the [MY
CAMERA] tab.)
To operate your contact's camcorder (when set to PLAY (VCR)
mode):
Click the [CONTACT] tab followed by the
(If your contact has a camcorder without NETWORK mode,
click the [CONTACT] tab. The camcorder of your contact
must be set to PLAY (VCR) mode for you to control the
playback functions.)
Operating Camcorders with DV Messenger
(VCR) tab.
(VCR) tab.
E
51