Operating Your Telephone Access Module; Calling Your Telephone Access Module - Honeywell W8735B Owner's Manual

Operating Your Telephone Access Module

When installing your Telephone Access Module, your
installer used the telephone hookup connection practice
described in the CAUTION. Do not alter your telephone
hookups without first consulting your installer.
CAUTION
Incorrect Telephone Line Hookup Hazard.
Inability to call out can result in personal
injury or property damage.
Improper installation can result in blocked
phone lines and inability to make 911 and
other emergency-reporting phone calls.
Always connect the Telephone Access Module
first in line. When a monitored security system
is installed, connect the Telephone Access
Module second in line.
Observing this practice ensures that
theTelephone Access Module drops off the line
to allow priority to the house telephone.

Calling Your Telephone Access Module

Carefully review the User and Configuration Menus
before operating your Telephone Access Module.
IMPORTANT:
The Telephone Access Module is designed to
provide remote access to your thermostat set-
tings and information. To access this informa-
tion or make changes, you must connect with
the Telephone Access Module from an out-
side line. If you want to access the Telephone
Access Module locally, you need to use a sec-
ond phone line or call from a cellular tele-
phone.
69-1353
PASS CODE
You will be asked to respond to the query, "Enter your
Pass Code followed by the # key."
You will be asked to enter a four-digit Pass Code. The
default Pass Code is 1 2 3 4. You can change this Pass
Code any time by entering the Configuration Menu. See
Configuring Your Telephone Access Module section for
complete instructions.
ALERT MESSAGES
You will hear this message, "A (alert message) is active."
The Telephone Access Module indicates an active alert
message immediately after you enter your Pass Code.
See Table 1 for a list of the alert messages and
corresponding causes. For additional information, see
Configuring Your Telephone Access Module section.
8
If the pass code is not entered
within six seconds after the
Telephone Access Module
answers the telephone and
begins transmitting data, hang up
and call again after 30 seconds.
The transmission of data is for
future applications. Be sure to
send in the Registration Card to
receive notice of future updates.