Table of Contents
Advertisement
W8735D TELEPHONE ACCESS MODULE
Battery Installation
NOTE: The use of the 9 Vdc battery is optional. However,
when the battery is installed, the power outage alert
option is available.
1. Press the latch on the top of the battery cover and pull it
down and away. See Fig. 19.
2. Connect 9 Vdc battery (not included) to the connector
leads.
3. Insert the battery in the battery compartment.
4. Insert the bottom tabs of the battery cover into the slots
on the case, then swing the battery cover up and in until
the top latch engages.
BATTERY
COVER LATCH
BATTERY COVER
9V BATTERY LEADS
BATTERY INSTALLED
Fig. 19. Battery Installation.
Connecting Power
Connect the 12 Vdc power to the W8735D power receptacle.
12 VDC POWER
Fig. 20. Power Connection.
69-2027—01
M23760
M23761
12
Connecting the Telephone Line
Connect the telephone line from an available telephone jack in
the equipment room to the telephone jack (RJ-11) on the
W8735D. Verify that service to the existing telephones is
available and all telephones are operational.
IMPORTANT:
Always use a DSL line filter if a DSL modem is
installed on the same telephone line as the W8735D.
Fig. 21. Telephone Connection.
The W8735D is equipped with an emergency telephone line
disconnect feature activated when another receiver in the
premise is picked up while the W8735D is connected. After
the W8735D installation is complete, be sure to verify that the
emergency telephone line disconnect is operating correctly.
1. Call the W8735D using an outside line (installers use a
cellular phone).
2. While connected to the W8735D, pick up a house tele-
phone receiver and try to acquire a dial tone by pressing
the flash key. If you hear the W8735D hang up a few
seconds later the W8735D is operating correctly, other-
wise check the phone lines and replace the device.
IMPORTANT
Do not leave the installation until the emergency tele-
phone line disconnect is operating correctly.
RJ-11 PHONE JACK
M23762
Advertisement
Table of Contents
