Honeywell W8735B Owner's Manual page 10

Alert Message
High Temperature
Low Temperature
Heat Pump
Heating System
Cooling System
Auxiliary Input
Filter Change
Power Outage
ACKNOWLEDGING ALERT MESSAGES
You will hear, "To acknowledge the alert message, press
1."
After the alert message is announced, the Telephone
Access Module prompts you to acknowledge the alert
message by pressing 1. If there is more than one active
alert message, the Telephone Access Module indicates
the next message, and continues until all alerts are
announced.
When you acknowledge the alert message, you are
clearing the dial-in alert message and also clearing the
dial-out alert.
69-1353
Table 1. Alert Messages.
The room temperature exceeded the high-limit temperature setting.
The room temperature exceeded the low-limit temperature setting.
A heat pump compressor fault occurred.
The system heat output is below the acceptable performance; possible heating
system failure.
The system cool output is below the acceptable performance; possible cooling
system failure.
The auxiliary sensor connected to the auxiliary input terminals tripped.
The thermostat is indicating that a filter change is required for the heating/cooling
system.
A power outage exceeded the maximum allowable time.
10
Possible Cause
IMPORTANT:
After receiving an alert, it is important to take
appropriate action immediately. See Receiv-
ing Dial-Out Messages section for more infor-
mation on dial-out alerts.
The Telephone Access Module continues through the
menu after the alerts are announced.
time.
To exit, press the * key at any