Remote Control; General; Maintenance; Cleaning - Dynex DX-32L152A11 User Manual

DX-32L152A11_10-0615_MAN_ENG_V1.book Page 16 Thursday, July 22, 2010 10:30 AM
16
DX-32L152A11
Problem Solution
The picture has a few bright • A few bright or dark spots on an
or dark spots. LCD screen is normal. It does not
affect the operation of this TV.
Good picture, but no • Make sure that the sound is not
sound. muted.
• Make sure that the sound mode is
set to Stereo or Mono. For more
information, see "Selecting the
audio mode" on page 13.
Audio noise. • Make sure that there is no
interference with infrared
equipment such as a cordless
telephone or headphones. Move
the infrared equipment away
from the TV to eliminate the
noise.

Remote control

Problem Solution
Remote control does not • Make sure that the TV power cord
work. is plugged in.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Make sure that the batteries are
installed correctly. For more
information, see "Installing
remote control batteries" on
page 6.
• Replace the batteries. For more
information, see "Installing
remote control batteries" on
page 6.
Trouble programming your • See instructions and a table of
existing universal remote common codes in "Programming
control. a universal remote control to
work with your TV" on page 7.
• Codes are subject to change. For
up to date codes, go to
www.dynexproducts.com.
• Replace the batteries. For more
information, see "Installing
remote control batteries" on
page 6.
• Refer to the User Guide that
accompanied your universal
remote control and contact the
manufacturer if problems persist.

General

Problem Solution
One or more channels do • Make sure that the channels are
not display. not blocked. For more
information, see "Setting parental
controls" on page 14.
Password is lost. • Enter 9999 to access parental
controls, then set a new
password. For more information,
see "Setting parental controls" on
page 14.
Some settings cannot be • If a setting is grayed, the setting is
accessed. not available in the current video
input mode.
TV cabinet creaks. • When the TV is in use, the
temperature rises naturally and
may cause the cabinet to expand
or contract which can cause a
creaking noise. This is not a
malfunction.
Control buttons on the TV • Disconnect the power cord, wait a
do not work. few seconds, then reconnect the
power cord and turn on the TV.
Note: If the problem is not solved by using these troubleshooting
instructions, try turning off your TV, then turning it on again.

Maintenance

Just like with any other household appliance, the performance and
life-expectancy of your TV depends on how well you maintain it. Follow
the procedures described here to clean the TV case and the LCD screen.
Cautions:
• Make sure that the TV is turned off and the power cord is
disconnected from the power outlet before cleaning the TV.
• Never spray or pour any liquid directly onto the screen or the case.

Cleaning

• Clean your TV with a soft, dry cloth. If surfaces are extremely
dirty, use a soft cloth dampened with a small amount of
non-ammonia, non-alcohol-based, non-abrasive detergent
solution.
• Clean the screen with a clean, soft, lint-free cloth. If additional
cleaning is necessary, apply a small amount of non-ammonia,
non-alcohol-based, non-abrasive detergent solution to the cloth.
Maintenance