Online User Manual; Troubleshooting; Video And Audio; Remote Control - Dynex DX-32L151A11 User Manual

4
DX-32L151A11/DX-37L130A11

Online User Manual

For the full user manual please go to
www.dynexproducts.com to download.

Troubleshooting

Before calling for service, check the following information for possible
solutions to problems you may experience. If none of these solutions
work, turn off the TV, then turn it on again.
Caution: Do not try to repair the TV yourself. Refer all servicing to
qualified repair personnel.

Video and audio

Problem
No picture (screen is not lit)
and no sound.
Dark, poor, or no picture
(screen is lit), but sound is
good.
No color, dark picture, or
color is not correct.
Only snow (noise) appears
on the screen.
Dotted lines or stripes
appear on the screen.
Double images.
The picture has a few bright
or dark spots.
Good picture, but no
sound.
Audio noise.
Solution
• Make sure that the power cord is
plugged in.
• Press POWER on the TV or the

remote control.

• Make sure that the correct video
input source is selected.
• Try another channel. The station
may be experiencing problems.
• Adjust the brightness. For more
information, see "Adjusting the TV
picture" in the online manual.
• Make sure that the correct picture
mode is selected.
• Make sure that the antenna or
cable TV is connected correctly
and securely.
• Adjust the color saturation.
• Try another channel. The station
may be experiencing problems.
• Make sure that the antenna or
cable TV is connected correctly
and securely.
• Check the signal strength.
• Adjust the antenna.
• Move the TV away from noise
sources such as cars, neon signs,
or hair dryers.
• Use a highly directional outdoor
antenna or cable TV.
• A few bright or dark spots on an
LCD screen is normal. It does not
affect the operation of this TV.
• Make sure that the sound is not
muted.
• Make sure that the sound mode is
set to Stereo or Mono.
• Make sure that there is no
interference with infrared
equipment such as a cordless
telephone or headphones. Move
the infrared equipment away
from the TV to eliminate the
noise.
Remote control
Problem
Remote control does not
work.
Trouble programming your
existing universal remote
control.

General

Problem
One or more channels do
not display.
Password is lost.
Some settings cannot be
accessed.
TV cabinet creaks.
Control buttons on the TV
do not work.
Note: If the problem is not solved by using these troubleshooting
instructions, try turning off your TV, then turning it on again.
Online User Manual
Solution
• Make sure that the power cord is
plugged in.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Make sure that the batteries are
installed correctly.
• Replace the batteries.
• See instructions and a table of
common codes in the online User
Manual.
• Codes are subject to change. For
up to date codes, go to
www.dynexproducts.com.
• Replace the batteries.
• Refer to the User Guide that
accompanied your universal
remote control and contact the
manufacturer if problems persist.
Solution
• Make sure that the channels are
not blocked.
• Make sure that the channels are
not hidden.
• The channel may have been
deleted from the channel list. You
can tune to the channel by
pressing the number buttons or
you can add the channel back to
the channel list.
• Enter 9999 to access parental
controls, then set a new
password.
• If a setting is grayed, the setting is
not available in the current video
input mode.
• When the TV is in use, the
temperature rises naturally and
may cause the cabinet to expand
or contract which can cause a
creaking noise. This is not a
malfunction.
• Disconnect the power cord, wait a
few seconds, then reconnect the
power cord and turn on the TV.