Specifications; Legal Notices - Dynex DX-32L152A11 User Manual

DX-32L152A11_10-0615_MAN_ENG_V1.book Page 17 Thursday, July 22, 2010 10:30 AM

Specifications

Specifications
Specifications subject to change without notice.
Weight and dimensions shown are approximate.
LCD
TV type
31.5-inch TFT LCD
TV panel
NTSC-M, ATSC
TV system
VHF: 2 - 13
Receiving channels
UHF: 14 - 69
CATV: 1 - 125
CADTV: 1-135
DTV: 2-69
BTSC system
Audio multiples
6 W x 2
Audio out
AC 120 V, 60 Hz
Power requirement
117 W
Power consumption
31.02 × 22.12 × 9.06 inches
Dimensions
(788 × 562 × 230 mm)
(W × H × D with stand)
20.51 lbs. (9.3 kg)
Weight
Composite video/L and R audio (1)
Input terminals
Component video/L and R audio (1)
HDMI (2)
VGA/audio (1)
ANT/Cable In (1)
Digital Coaxial Audio (1)
Output terminals
Headphone (1)
SERVICE PORT (1)
Control terminals

Legal notices

FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this
product is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply within the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modifications not expressly approved by the party
responsible for compliance with the FCC Rules could void the user's
authority to operate this equipment.
Cables
Connections to this device must be made with shielded cables with
metallic RF/EMI connector hoods to maintain compliance with FCC
Rules and Regulations.
Canada ICES-003 statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la classe B est conforme a la norme NMB-003
du Canada.
Standard Television Receiving Apparatus — Appareil de réception
télévision ordinaire, Canada BETS-7 / NTMR-7
HDMI
HDMI, the HDMI logo, and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LCC.
17
DX-32L152A11