Exiting The Rom Monitor - Cisco VG204 Software Configuration Manual

Exiting the ROM Monitor

•
Exiting the ROM Monitor
You must set the configuration register to a value from 0x2 to 0xF for the voice gateway to boot a
Cisco IOS image from flash memory upon startup or reloading.
The following example shows how to reset the configuration register and cause the voice gateway to
boot a Cisco IOS image stored in flash memory:
rommon 1 > confreg 0x2101
You must reset or power cycle for new config to take effect:
rommon 2 > boot
The voice gateway will boot the Cisco IOS image in flash memory. The configuration register will
change to 0x2101 the next time the voice gateway is reset or power cycled.
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
A-8
FP: 0x80005f9c, PC: 0x80008118
FP: 0x80005fac, PC: 0x80008064
FP: 0x80005fc4, PC: 0xfff03d70
FP: 0x80005ffc, PC: 0x00000000
FP: 0x00000000, PC: 0x00000000
meminfo—Displays size in bytes, starting address, available range of main memory, the starting
point and size of packet memory, and size of NVRAM; for example:
rommon 9> meminfo
Main memory size: 128 MB.
Available main memory starts at 0x10000, size 40896KB
IO (packet) memory size: 5 percent of main memory.
Appendix A Using the ROM Monitor
OL-16191-01