Completing The Configuration - Cisco VG204 Software Configuration Manual

Chapter 2 Using the setup Command Facility
!
interface FastEthernet0/0
media-type 100BaseX
half-duplex
ip address 9.13.38.150 255.255.255.0
!
interface FastEthernet0/1
shutdown
no ip address
dialer-list 1 protocol ip permit
!
end

Completing the Configuration

When you have all the information that the setup command facility has prompted you for, the
configuration appears.
To complete your configuration, follow these steps:
Step 1 A setup command facility prompt asks if you want to save this configuration, with the following options:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you answer 0, the configuration information you entered is not saved, and you return to the Cisco VG
enable prompt (
If you answer 1, you return to setup without saving the configuration.
If you answer 2, the configuration is saved and you are returned to the user EXEC prompt
When the messages stop appearing on your screen, press Return to get the
Step 2
The
Step 3
completed a basic Cisco VG configuration. However, this is not a complete configuration. At this point
you have two choices:
•
•
OL-16191-01
). Enter setup to return to the System Configuration Dialog.
VG#
prompt indicates that you are now at the command-line interface (CLI) and you have just
VG>
Run the setup command facility again and create another configuration. Enter the following:
VG> enable
Password: password
VG# setup
Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, "Configuring with the Command-Line Interface."
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
Completing the Configuration
.
(VG>)
prompt.
VG>
2-5