Marvell ® Raid Configurations - Asus M3A32-MVP - Deluxe Motherboard - ATX User Manual

5.4.4 Marvell
The Marvell ® 6121 Serial ATA controller allows you to configure RAID 0 and RAID 1
sets on the Serial ATA hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Install two internal Serial ATA hard disk drives to the SATA connectors labeled
SATA_RAID1/2.
2. Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
In the Advanced Menu, go to Onboard Devices Configuration, and enable
3.
both Marvell 6121 SATA Controller and Marvell Option ROM.
Set Marvell IDE/RAID function to [RAID].
4.
Advanced
Onboard Devices Configuraiton
Serial Port1 Address
Serial Port1 Mode
HD Audio Azalia Device
Front Panel support Type
Onboard Lan
Onboard Lan Boot Rom
Marvell 6111 SATA Controller [Enable]
Marvell 6121 SATA Controller [Enable]
Marvell Option ROM
Marvell IDE/RAID function
Primary Display Adapter
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
3. Press <F10> to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
ASUS M3A32-MVP Deluxe Series
RAID configurations
®
BIOS SETUP UTILITY
[3F8/IRQ4]
[Normal]
[Auto]
[HD Audio]
[Enable]
[Disabled]
[Enable]
[RAID]
[PCI-E]
Allows BIOS to select
Serial Port1 Base
Addresses.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
5-43