Marvell Sas Raid Configurations - Asus P6T7 WS SuperComputer - Motherboard - SSI CEB User Manual

4.4.5 Marvell
The Marvell
®
hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set.
To do this:
1. Install two internal SAS hard disk drives to the SAS connectors labeled
SAS1/2.
2. Boot up your computer, and press <Del> during POST to enter the BIOS
setup.
In the Advanced menu, go to Onboard Devices Configuration, and enable
3.
both Marvell SAS and SAS Boot ROM.
4. Press <F10> to save the changes and exit.
Onboard Devices Configuration
High Definition Audio
Front Panel Type
Marvell Storage Controller
Marvell Storage Boot ROM
Marvell SAS
SAS Boot ROM
Realtek LAN1
Realtek LAN2
LAN Boot ROM
Onboard 1394 Controller
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
4-50
SAS RAID configurations
®
SAS controller allows you to configure RAID 0 and 1 set on the SAS
Advanced
[Enabled]
[HD Audio]
[Legacy Mode]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
BIOS SETUP UTILITY
Options
Enabled
Disabled
Chapter 4: Software support