Raid Configurations; Raid Definitions; Creating A Raid Driver Disk - Asus M3A32-MVP - Deluxe Motherboard - ATX User Manual

5.4

RAID configurations

The motherboard comes with two RAID controllers that allow you to configure
Serial ATA hard disk drives as RAID sets.
AMD SB600 Southbridge RAID includes a high performance SATA RAID
•
controller that supports RAID 0, RAID 1, and RAID 0+1 for four independent
SATA channels.
Marvell
• ®
supports RAID 0 and RAID 1 for two independent SATA channels.
5.4.1

RAID definitions

RAID 0 (Data striping) optimizes two identical hard disk drives to read and write
data in parallel, interleaved stacks. Two hard disks perform the same work as a
single drive but at a sustained data transfer rate, double that of a single disk alone,
thus improving data access and storage. Use of two new identical hard disk drives
is required for this setup.
RAID 1 (Data mirroring) copies and maintains an identical image of data from
one drive to a second drive. If one drive fails, the disk array management software
directs all applications to the surviving drive as it contains a complete copy of
the data in the other drive. This RAID configuration provides data protection and
increases fault tolerance to the entire system. Use two new drives or use an
existing drive and a new drive for this setup. The new drive must be of the same
size or larger than the existing drive.
RAID 0+1 is data striping and data mirroring combined without parity (redundancy
data) having to be calculated and written. With the RAID 0+1 configuration you get
all the benefits of both RAID 0 and RAID 1 configurations. Use four new hard disk
drives or use an existing drive and three new drives for this setup.
If you want to boot the system from a hard disk drive included in a RAID set,
copy first the RAID driver from the support DVD to a floppy disk/USB device
before you install an operating system to a selected hard disk drive. Refer to
section 5.6 Creating a RAID driver disk for details.
5-36
6121 RAID includes a high performance SATA RAID controller that
Chapter 5: Software support