4.
Marvell
6121 Serial ATA RAID connector (7-pin SATA_RAID1/2)
®
This connector is for a Serial ATA signal cable that supports a Serial ATA hard
disk drive. To configure RAID 0 or RAID 1, install two internal Serial ATA hard
disk drives to the SATA_RAID1/2 connectors.
The Marvell IDE/RAID function item in BIOS is set to [IDE] by default. Setting
this item to [RAID] allows you to use the connectors to build a RAID set. See
section 4.4.5 Onboard Devices Configuration for details.
®
M3A32-MVP DELUXE
SATA RAID connectors
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the Marvell RAID BIOS Configuration utility
and SATA BIOS setup during POST.
ASUS M3A32-MVP Deluxe Series
SATA_RAID1
SATA_RAID2
2-31