To Remove A Cd From The Cd-Rom Drive; About Audio Cds - HP OmniBook 800 User Manual

To remove a CD from the CD-ROM drive

1. Make sure the blinking "Busy" message does not appear on the CD-ROM drive
2. Press OPEN to open the disk cover.
3. Press down on the center of the CD and gently lift the outside edge until the CD
4. Close the disk cover and return the CD to its storage case.

About Audio CDs

There are three ways to play audio CDs. In all three methods, the CD-ROM drive can
remain connected to your OmniBook, although the first two do not require it.
Note When you use the OmniBook to control the CD-ROM drive, the CD-ROM drive audio
control buttons are deactivated. To reactivate the control buttons, stop the CD-ROM
drive using the CD audio software, then open and close the disk cover.
display. If "Busy" appears, stop the CD using either the OmniBook software or
the CD-ROM drive control buttons.
is free.
Connect the CD-ROM drive PHONES jack to your sound system LINE-IN jack
with an audio connecting cable (cable not supplied). In this case the CD-ROM
drive functions as a conventional audio CD player.
Connect headphones (not supplied) or amplified speakers (not supplied) to
the CD-ROM drive and use it as a stand-alone audio CD player. Make sure the
CD-ROM drive is stable and vibration-free; carrying it while jogging or walking is
not recommended.
Connect the CD-ROM drive PHONES jack to the OmniBook's line-in jack with an
audio connecting cable (cable not supplied). Use audio CD software of your
choice to control the CD-ROM drive.
1-13