Advertisement
Available languages
Available languages
Slowly r oute w ater s upply line through h ole incabinet. (Ifusing
copper tubing, itwillbend a nd kink easily, sobegentle.) Lt
should b efarenough intothe cabinet opening toconnect itto
the dishwasher
inlet o nthe front l eft
side ofthedishwasher.
Slowly turn water s hutoff valve t o"ON" position. Flush w ater
intoashallow p an until clear t ogetridofparticles thatcould
clog theinlet v alve. Turn shutoff valve t o"OFF" position.
IMPORTANT:
Always u se anew drain h ose. Check l ocal codes
todetermine ifanairgap isrequired.
Ifneeded, drill a 11/2" (3.8 cm) d iameter hole incabinet wall o rside
oftheopening closest tothesink.
Route d rain hose a sshown t hrough h ole incabinet tothe front
center ofopening where d rain connection
willbemade. Tape
drain hose t othe floor i narea shown. This willprohibit itfrom
moving w hen d ishwasher
ismoved intocabinet opening.
, Option A; Waste disposer _n0 air gap
i Option B, No Waste disP0ser-no
air gap
, Option C, Waste disposer : with air gap
' opt 0n D, No waste disp0ser-
with air gap
IMPORTANT:
The drain hose connection
of the disposer
or a
waste tee must be made before the drain trap and at least 20"
(50.8 cm) above the floor where the dishwasher
will be installed.
Helpful
Tip: To reduce vibration
of the hose, keep the hose away
from the floor.
Option A, Waste disposer
- no air gap
t
;t
;
:i
1. Using a hammer
and screwdriver,
knock
plug into disposer.
2. Use needle-nose
pliers to remove
plug.
3. Attach
drain hose to disposer
inlet with
large silver drain hose clamp (provided).
Use pliers to squeeze
clamp open and
move into position.
Advertisement
