Advertisement
Available languages
Available languages
• A new drain hose is supplied
with your dishwasher.
If this is not long enough,
use a new drain hose with a maximum
length of 12' (3.7 m)(Part
Number
3385556)
that meets all
current
AHAM/IAPMO
test standards,
is resistant
to heat and
detergent,
and fits the 1" (2.5 cm) drain connector
of the
dishwasher.
• Make sure to connect
drain hose to waste tee or disposer
inlet
above drain trap in house plumbing
and 20" (50.8 cm) minimum
above the floor. It is recommended
that the drain hose either be
looped up and securely
fastened
to the underside
of the counter,
or be connected
to an
air gap.
• Make sure to use an air gap if the drain hose is connected
to
house plumbing
lower than 20" (50.8 cm) above subfloor
or floor.
• Use 1/2" minimum
I.D. drain line fittings.
• If required the air gap should
be installed
in accordance
with the air gap installation
instructions,
when connecting
the air
gap a rubber
hose (not provided)
will be needed to connect
to the
waste tee or disposer
inlet.
• A hot water
line with
20-120
psi ( 138-862
kPa) water
pressure
can be verified
by a licensed
plumber.
• 120 ° F (49 °C) water
at dishwasher.
• 3/8" O.D. copper tubing
with compression
fitting
or
flexible
braided water
supply line (Part Number
4396897RP)
NOTE: 1/2" minimum
plastic tubing
is not recommended.
• A 90 ° elbow with 3/8" N.P.T. external
pipe threads
on one
end.
• Do not solder within
6" ( 15.2 cm) of the water
inlet valve.
Be sure that the electrical
connection
and wire size are adequate
and in conformance
with the National
Electrical
Code, ANSI/NFPA
70 - latest edition
and all local codes and ordinances.
A copy of the above code standards
can be obtained
from:
National
Fire Protection
Association
1 Batterymarch
Park
Quincy, MA 02269
You must have:
• 120-volt,
60 Hz, AC-only, 15- or 20- amp., fused electrical
supply.
• copper
wire only.
We recommend:
• a time-delay
fuse or circuit
breaker.
• a separate
circuit.
if connecting
dishwasher
with
a power
supply
cord:
• Use UL Listed power
supply cord kit (Part
Number
4317824)
marked
for use with dishwasher.
• Power supply cord must plug into
a grounded
3 prong outlet, located
in the
cabinet
next to the dishwasher
opening.
Outlet must meet all local codes and
ordinances.
If connecting
dishwasher
with
direct
wiring:
• Use flexible,
armored
or
non-metallic
sheathed,
copper wire with
grounding
wire that meets
the wiring
requirements
for your home and local codes and
ordinances.
• Use a UL Listed/CSA
Approved
strain relief.
Advertisement
