Epson Progression Setup Manual page 42

7. You see the prompt Enter
password and press
changes to Set.
Note
Be sure to remember the password you enter or write it
down and keep it in a safe place. If you cannot
remember it, you will not be able to use the computer
the next time you turn it on. If you forget your
password, however, there is a way to access your
system. See "Password Problems" in Chapter 7 of the
User's Guide for more information.
8. If you will be using your computer as a network server and
want to set your password to operate in a special network
security mode, highlight Network server mode and
press El
from Not installed to Installed. (See "Using Your
Computer as a Network Server" in Chapter 1 of the User's
Guide for information about network server mode.)
Note
To provide complete security, be sure to lock the cover onto
your computer. See Chapter 1 of the User's Guide for
instructions.
After you set a password, you can change or delete it when you
are using the SETUP program or when you are entering the
password to access your computer. Follow the steps in the
appropriate section below to change or delete an existing
password in SETUP. See Chapter 1 of the User's Guide for
instructions on entering, changing, and deleting your password
as you access your computer.
2-16 Running SETUP Program
Password Again.
Type your