Running The Setup Program - Epson Progression Setup Manual

If your computer was not preconfigured, you need to run the
SETUP program the first time you use your computer to define
how your system is set up. You may need to run it again later if
you change some part of your configuration.
The SETUP program is stored in the computer's read-only
memory (ROM), so you can run the program any time you turn
or reset your computer.
on
SETUP lets you verify or change the following:
Current date and time
Installed base and extended memory
Processor speed settings
Fast boot option
Location of the built-in video BIOS
System and video shadow RAM address operation
Keyboard delay, speed, and num lock status
Installed equipment information
Parallel and serial port operation and address assignments
Speaker operation
Built-in diskette drive and hard disk drive controller
operation
Password and network server mode operation

Running the SETUP Program

2-1