Advertisement
Once the studio monitors have been placed in their final location, it is time to proceed to connecting your
PM0.5 MKⅡ studio monitors to the mixing console or digital workstation. Connection to the PM0.5 MKⅡ can be
made using XLR or TRS connectors. The gain control on the back of the monitor allows continuously variable
adjustments to match most input types from -10dBV to +4dBu. The input is electronically balanced and is
compatible with unbalanced sources, although this may require an adapter. The connection of the PM0.5 MKⅡ
to the console/digital workstation should be done in the following order.
Step 1: Make sure that all equipment has been powered down.
Step 2: Confirm that all gain controls, on the monitor and the source, are set to the minimum setting.
Step 3: Connect the source to the PM0.5 MKⅡ monitor.
Step 4: Power up the all source equipment and then turn on the PM0.5 MKⅡ last.
Step 5: Set the gain of both monitors at medium setting and slowly bring up the gain of the console.
Step 6: Adjust the gain of both monitors for balance and for best signal to noise ratio
Once the above steps have been completed, you are ready to use your PM0.5 MKⅡ monitors. It is
recommended that you now play some familiar audio material and make any final adjustments, as far
as placement or level, to get the optimum performance in your monitoring environment.
1. XLR & TRS Combination Input
This input is an electronically balanced input and
is compatible with both -10dBV and +4dBu
signals.
2. Continuously variable gain control
This control adjusts the input level to the internal
amplifiers.
3. Heatsink
The heatsink dissipates heat from the amplifier. It
is important the heatsink receives proper
ventilation and is not placed near any sources of
heat.
4. Power Switch
Turns power to the amplifier section on or off.
On - position is the spot side.
5. Standard IEC Power Input
This power terminal should be used with a
properly grounded three pin power cable, such as
the one provide with the product.
Setup Instructions continued
Back Panel Overview
1
INPUT
2
3
POWER
4
AC IN
5
MADE IN CHINA
GAIN
PM0.5 MKⅡ
CAUTION:
OFF
MAX
HEATSINK MAY GET HOT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUD DE CHOC ELECTRIQUE
NE PAS OUVRIR
WARNING:
To reduce the risk of fire or electrical
shock, do not expose this equlpment to rain or
moisture. Do not remove cover. No user serviceable
parts inside. Refer servicing to quallfied personnel.
CM
C
US
3024002
CONFORMS TO
UL STD.6500
CERTIFIED TO
CAN/CSA STD.E60065
p-5
Advertisement
