NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 62

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
This screen shows the following parameters:
Table 4-1. General Information Fields
Field
Access Point Information
Access Point Name (NetBIOS
name)
MAC Address
Country/Region
Firmware Version
Access Point Mode
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings
Operating Mode
Wireless Network Name (SSID)
Channel/Frequency
WEP/WPA
AutoCell
Rogue AP Detection
4-6
Description
The default name may be changed if desired.
Displays the Media Access Control address (MAC address) of the
wireless access point's Ethernet port.
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access
point in a region other than one of those identified in this field.
The version of the firmware currently installed.
Identifies the operating mode of the WG302: Access Point,
Point-to-point bridge, Multi-point bridge or Repeater.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a
DHCP server on your network. Disabled indicated a static IP
configuration.
Identifies the 802.11 operating mode of the WG302.
Displays the wireless network name (SSID) being used by the
wireless port of the wireless access point. The default is NETGEAR.
Identifies the channel the wireless port is using. 11 is the default
channel setting. See "Wireless Channels" on page B-7
frequencies used on each channel.
WEP/WPA setting.
AutoCell setting.
Rogue AP detection setting.
July 2005 v3.0
for the
Management