NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 32

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
Note: By default, WG302 is set to with the DHCP client disabled. If your network uses
dynamic IP addresses, you will need to change this setting.
Connect the power adapter to the wireless access point and plug the power adapter in to a
d.
power outlet. The PWR, LAN, and Wireless LAN lights and should light up.
4 V W
ERIFY IRELESS
Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless
settings needed to connect to the WG302 (SSID, WEP/WPA, MAC ACL, etc.), verify
connectivity by using a browser such as Netscape or Internet Explorer to browse the Internet,
or check for file and printer access on your network.
Note: If you are unable to connect, see
3-10
C
ONNECTIVITY
Chapter 6,
July 2005 v3.0
"Troubleshooting."
Basic Installation and Configuration