NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 21

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
The following table explains the LED indicators:
LED DESCRIPTION
PWR Power Indicator
Off No power.
On Power is on.
TEST Self Test Indicator
Blink Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
100 Ethernet LAN Speed Indicator
Off Indicates 10 Mbps Ethernet link detected
Green On 100 Mbps Fast Ethernet link detected.
LINK/ACT LAN Ethernet LAN Link Activity Indicator
Off Indicates no Ethernet link detected.
Green On 100 Mbps Fast Ethernet link detected, no activity.
Green Blink Indicates data traffic on the 100Mbps Ethernet LAN.
Amber 0n 10 Mbps Ethernet link detected, no activity.
Amber Blink Indicates data traffic on the 10Mbps Ethernet LAN.
802.11g WLAN Wireless LAN Link Activity Indicator
Off Indicates no wireless link activity.
Green Blink Wireless link activity.
Figure 2-2: WG302 rear panel
Introduction
July 2005 v3.0
2-7