Table of Contents
Advertisement
46 Monitor Properties
Apply your settings
1
Click Apply to save your changes and leave the Catalyst™ Control
Center open.
2
Click OK to save your changes and exit the Catalyst™ Control
Center.
Discard your settings
• Click Discard to ignore any unsaved changes and restore the
settings that existed when the Catalyst™ Control Center was
opened or the last time Apply was used. Discard does not close the
Catalyst™ Control Center.
Clicking Discard applies to all features of an aspect, not just the feature in
the current view.
Restore default settings
1
Move the mouse to the bottom right-hand corner of the window.
2
Click Defaults.
Note: Clicking Defaults will restore the defaults for the current view
only. Previous settings are not altered and will be saved once you
click OK.
Monitor Properties
Use the Monitor Properties aspect to configure your Display Data Channel
(DDC) monitor's attributes, to display information about the connected
monitor, and adjust the output display's position and size.
Note: Catalyst™ Control Center loads aspects dynamically based on
what device is attached to the graphics card. If you have a display
device other than a standard monitor or flat panel display (such as a
HDTV screen) Digital Panel Properties will appear in the Graphics
Settings listing instead of Monitor Properties.
To access the Monitor Properties aspect
• Select Monitor Properties in Advanced View.
Advertisement
Table of Contents
