Table of Contents
Advertisement
CHAPTER 2:
Installing Hardware
This chapter will guide you through the physical installation of your
FireGL™ card.
Detailed Installation
The following instructions will take you step by step through the
installation of your new FireGL™.
Installing the graphics card
1
Turn off the computer, monitor, and other peripheral devices.
2
Unplug the computer's power cord and disconnect all cables from the
back of your computer.
WARNING
power cord before disconnecting a peripheral or removing a
component from the motherboard to avoid possible damage to the
motherboard.
3
Remove the computer cover.
If necessary, consult your computer's manual for help in removing
the cover.
WARNING
touching the power supply or the metal surface of the computer
chassis.
4
Unscrew or unfasten and remove any existing graphics card from
your computer.
Note: If your computer has an on-board graphics capability, you may
need to disable it on the motherboard. For more information, see your
computer documentation.
- Wait approximately 20 seconds after unplugging the
- Remember to discharge your body's static electricity by
Detailed Installation 5
Advertisement
Table of Contents
Need help?
Do you have a question about the V7350 - 100-505143 FireGL 1GB 512-bit GDDR3 PCI Express Video Card and is the answer not in the manual?