Table of Contents
Advertisement
CHAPTER 2:
Installing Hardware
This chapter will guide you through the physical installation of your
FireGL™ V5100 card.
Quick Installation
Experienced users and system administrators can follow these brief
instructions for installing the FireGL™ V5100 card in the shortest possible
time.
To perform a quick installation
1
Uninstall the drivers and software for your old graphics card if you
have not already done so.
Note: If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a multiple
monitor display, disable it.
2
Shut down and disconnect your computer system.
3
Remove any previously installed card.
4
Install your new FireGL™ V5100 card.
5
Reassemble and connect your computer system.
6
Install the FireGL™ V5100 drivers and configuration software from
the ATI Installation CD-ROM by doing one of the following:
• Run through the automatic ATISETUP utility; or
• Start > Run > X:\ATISETUP.EXE (where X is the drive letter of
your CD-ROM drive).
Detailed Installation
The following instructions will take you step by step through the
installation of your new FireGL™ V5100.
Quick Installation 5
Advertisement
Table of Contents
