Table of Contents
Advertisement
Display
Configuration
CRT display +
DFP display +
Quad-buffered
stereographics
device
CRT display +
CRT display +
Quad-buffered
stereographics
device
Turning on the System
WARNING
computer. Failure to do so could damage your monitor.
If you have properly installed your graphics card, operating system
messages will appear once the boot procedure is finished.
Your monitor will be running in a basic video mode. Higher refresh rates
are not available at this stage of the installation. Once you have installed the
FireGL™ drivers and software, you can use the Display Properties control
panel to adjust the video settings and configure multiple monitors.
Connector(s)
Used
VGA connector
with VGA-to-DVI-I
adapter +
DVI-I connector +
Quad-buffered
stereographics
VGA connector
with VGA-to-DVI-I
adapter +
VGA connector
with VGA-to-DVI-I
adapter +
Quad-buffered
stereographics
- Turn on your monitor before you turn on your
Display Configurations 9
Comments
Check driver release notes for
limitations on the use of
stereographics.
Check driver release notes for
limitations on the use of
stereographics.
Advertisement
Table of Contents
Need help?
Do you have a question about the V7350 - 100-505143 FireGL 1GB 512-bit GDDR3 PCI Express Video Card and is the answer not in the manual?