Quick Installation - ATI Technologies V7350 - 100-505143 FireGL 1GB 512-bit GDDR3 PCI Express Video Card User Manual

4 Quick Installation

3
Select your current graphics card drivers and select Add/Remove.
The wizard will help you remove your current display drivers.
Note: If the previously installed graphics card has any additional
software installed, it should also be removed at this point.
4
Turn off your system and remove the old graphics card.
Quick Installation
Experienced users and system administrators can follow these brief
instructions for installing the FireGL™ card in the shortest possible time.
Detailed hardware and software installation instructions are given in the
next two sections.
To perform a quick installation
1
Uninstall the drivers and software for your old graphics card if you
have not already done so.
Note: If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a multiple-
monitor setup, disable it.
2
Shut down and disconnect your computer system.
3
Remove any previously installed card.
4
Install your new FireGL™ card.
5
Reassemble and connect your computer system.
6
Install the FireGL™ drivers and configuration software from the ATI
Installation CD-ROM by doing one of the following:
• Run through the automatic ATISETUP utility; or
• Start > Run > X:\SETUP.EXE (where X is the drive letter of
your CD-ROM drive).