Advertisement
4. Sequencer Mode
4.1 MIDI reception/transmission block diagram
(Receive flow chart)
sw1
MIDI
sw2
sw3
sw5
sw6
sw4
Notes: sw1
Receive channels during recording.
sw2
Control change on/off in SEQ SETUP during recording.
sw3
Aftertouch on/off in SEQ SETUP during recording.
sw4
System exclusive on/off in SEQ SETUP during recording.
sw5
Turns on when clock is set to MIDI in SEQ SETUP.
sw6
MIDI control on/off in SEQ SETUP.
(Transmit flow chart)
NOTE ON/OFF
$9n
$Bn
$00
BANK SELECT
$20
CONTROL CHANGE
$Bn
PITCH BEND
$En
PROGRAM CHANGE
$Cn
CH. AFTER TOUCH
$Dn
POLY. AFTER TOUCH
$An
MIDI CLOCK
$F8
START
$FA
CONTINUE
$FB
STOP
$FC
SONG POSITION
$F2
SYSTEM EXCLUSIVE
$F0
see synth part
Notes: sw1
Track Transmit Channel.
sw2
Bank select on/off in SEQ SETUP.
sw3
Control change on/off in SEQ SETUP.
sw4
Program change on/off in SEQ SETUP.
sw5
MIDI control on/off in SEQ SETUP.
4.2 Channel Message
Reception is carried out only during recording. Transmission is performed only when
playing and overdubbing. Refer to Receive and Transmit flow charts for reception
and transmission conditions. Polyphonic Aftertouch can be transmitted and received,
but the internal tone generator will not recognize it.
4.3 Mode Message
Transmission and reception is carried out.
4.4 System Common Message
Only $F2 and $F3 are received, and the others are not transmitted nor received.
4.5 System Realtime Messages
4.5.1 Status F8, FA, FB, FC are received.
$9n NOTE ON/OFF
$8n NOTE OFF
$Bn CONTROL CHANGE
$En PITCH BEND
$Cn PROGRAM CHANGE
$Dn CHANNEL AFTER TOUCH
$An POLYPHONIC AFTER TOUCH
$F8 MIDI CLOCK
$FA START
$FB CONTINUE
$FC STOP
$F2 SONG POSITION POINTER
$F3 SONG SELECT
$F0 SYSTEM EXCLUSIVE
see synth part
sw1
sw2
sw3
sw4
sw5
4.5.2 After status F9, FD, FF are read, nothing will be carried out.
4.6 System Exclusive Messages
During recording, W5/W7 will not respond to dump request.
5. Status FE (Active Sensing)
a) Transmission
FE is transmitted approximately every 170 msec.
b) Reception
If a signal is not output from MIDI for longer than approximately 300 msec after
receiving FE, the MIDI reception buffer is cleared, and if key on remains it is turned
off.
MIDI
4 3
Advertisement
