Connecting DVD-VCR to the TV using the Coaxial Cable
To receive television programmes a signal must be received from
one of the following sources:
N An outdoor aerial
N An indoor aerial
N A cable television network
N A satellite receiver
☛
Make sure that both the television and the DVD-VCR are
switched off before connecting the cables.
1
Remove the aerial or network input cable from the television.
2
Connect this cable to the 75Ω coaxial socket marked
rear of your DVD-VCR.
3
Plug the coaxial cable supplied into the
DVD-VCR.
4
Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
5
To obtain better quality pictures and sound on your television, you
can also connect your DVD-VCR to the television via the RCA
cable (see section below) if your television is equipped with this
type of connection.
Connecting DVD-VCR to the TV using the RCA Cable
RF coaxial cable
You can connect your DVD-VCR to the television using the RCA cable if the appropriate input is available
on the television. You thus:
N Obtain better quality sound and pictures
N Simplify the setting up procedure of your DVD-VCR
☛
N Regardless of the type of connection chosen, you must always connect the coaxial cable supplied.
Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.
N Make sure that both the television and the DVD-VCR are switched off before connecting the cables.
1
Connect the coaxial cable as indicated in the above section.
2
Connect one end of the RCA Audio/Video cable to the Video output and Audio L, R output socket on the rear of
the DVD-VCR.
3
Plug the other end into the appropriate connector on the television.
socket on your
TV
TV
3
on the
TV
4
2
2
GB
3
Aerial
11