Table of Contents
Advertisement
Connecting DVD-VCR to the TV using the Coaxial Cable
To receive television programmes a signal must be received from
one of the following sources:
An outdoor aerial
An indoor aerial
A cable television network
A satellite receiver
Make sure that both the television and the DVD-VCR are
switched off before connecting the cables.
1
Remove the aerial or network input cable from the television.
2
Connect this cable to the 75 coaxial socket marked
rear of your DVD-VCR.
3
Plug the coaxial cable supplied into the
DVD-VCR.
4
Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
5
To obtain better quality pictures and sound on your television, you
can also connect your DVD-VCR to the television via the SCART
cable (see section below) if your television is equipped with this
type of connection.
Connecting DVD-VCR to the TV using the SCART Cable
TV
SCART Cable
RF coaxial cable
You can connect your DVD-VCR to the television using the SCART cable if the appropriate input is
available on the television. You thus:
Obtain better quality sound and pictures
Simplify the setting up procedure of your DVD-VCR
Regardless of the type of connection chosen, you must always connect the coaxial cable
supplied. Otherwise, no picture will be visible on the screen when the DVD-VCR is switched
off.
Make sure that both the television and the DVD-VCR are switched off before connecting the
cables.
1
Connect the coaxial cable as indicated in the above section.
2
Connect one end of the SCART cable to the AV1 (EURO AV) socket on the rear of the DVD-VCR.
3
Plug the other end into the appropriate connector on the television.
TV
socket on your
3
on the
TV
Aeria
2
2
4
3
11
GB
Advertisement
Table of Contents
